GENERAL INFORMATION

  • Extruder: Single extrusion
  • Extruder temperature: Up to 230°C /397°F
  • Operating Interface: 3.5” full color IPS touch screen
  • Maximum Build Volume: 10” x 6” x 6.7” / 255 mm x 155 mm x 170 mm
  • Layer Thickness: 4 mil | 0.004 inches 100 microns | 0.10 mm
  • USB Stick: Up to 64GB
  • Internal Storage: 4GB
    Weight(without spool)
  • 35 pounds (16 kg)
    Dimensions
  • Height: 20.25 inches (514 mm)
  • Width: 16 inches (406 mm)
  • Depth: 15.9 inches (403 mm)

FILAMENT

  • ONLY builds Dremel PLA filaments
  • Filament: 1.75mm PLA (Blodegradable/Renewable)
Storage
  • All polymers degrade with time. The following conditions ensure the material remains high quality:
    • Do not unpack until filament is needed
    • Store at room temperature: 16-29° C / 60 - 85° F
    • Store in a dry environment

SOFTWARE

  • Dremel 3D40 comes with complimentary software. This application converts your 3D digital files into buildable model files.
Windows Requirements
  • Print Studio Software runs on 64-bit Operating Systems Windows 7 or later
MAC OS X Requirements
  • Print Studio Software runs on Mac OS X v10.10 (Yosemite) or later

HARDWARE

  • A PC with the below minimum requirements will be required to run the Print Studio Software
    • Processor: Multi-core processor - 2 GHz or faster per core
    • System RAM: 2 GB
    • Screen Resolution: 1024x768
    • USB Port
    • Video Graphics Card to support OpenGL 2.1 or later

ELECTRICAL

  • 3D40 input rating: 100V - 240V, 50/60Hz 0.8A - 1.8A

ENVIRONMENT

  • Room Temperature: 16-29° C (60 - 85° F)
  • Level workspace
  • Dry workspace environment

WARRANTY